Recent content by raymond

  1. R

    SB Air Gap mods

    Thanks for the response, it has a butchered up LD340 on it now with pretty much the complete divider missing out of it, right down to the plenum floor and even removed under the roof towards the front, although it seems to run half OK I don't see the total fuel distribution being great.
  2. R

    SB Air Gap mods

    That's the problem. very close to the hood now, thanks for your response.
  3. R

    SB Air Gap mods

    Hi, anyone have any thoughts or info on SB Air Gap plenum mods similar to the LD 340 mods from decades past, I've seen vids where there have been improvements on the dyno after cutting the divider down on a SB Chev AG, just wondering if anyone has given theirs a bit of a cut and if so is there...
  4. R

    LD340 v Airgap

    Thanks for your thoughts, yeah it seems the airgap is out of stock everywhere I look but I wasn't planning on going with the china one. The best price I can see her in OZ was from Amazon believe it or not, but they have no stock either, [not a cheap option to ship from US] I've ordered from them...
  5. R

    LD340 v Airgap

    I'm down under, the LD has other problems as well it looks to have been pretty badly corroded in the water ports and was welded then machined, by a blind person by the look of it, it is now 'low' at 5/7 ports , trying to fix it is $$$prohibitive, for me anyhow, I'm over it. Thanks for you...
  6. R

    LD340 v Airgap

    The problem is the plenum has probably been butchered past the point of fixing it, it's a real mess. The heads are already flowing in the mid 280,s. My thoughts were to try an Air Gap to get away from the butchered LD and take advantage of the slight gains the AG is said to have.
  7. R

    LD340 v Airgap

    Thanks for the reply, my LD has the TQ mods plus when I got hold of it the WHOLE divider had been removed along with just about everything else in the plenum, it's not a pretty sight, I'm thinking the mods haven't helped it. Its in a 68 Dart has around 10.8 or 9 comp Eddies at mid 280's hyd /...
  8. R

    LD340 v Airgap

    Hi guys , anyone swapped from an LD 340 to an airgap on a 360 and if so did you see any improvements? Any input would be much appreciated, thanks
  9. R

    Dual Snorkel cold air setup

    Don't laugh, I run a dryer tube system and back to back runs at the track, With / without, it is worth 2 tenths and 2 MPH,
  10. R

    Low fuel pressure after making pass down track

    Is your tank properly vented ?
  11. R

    Probably about time-rocker adjustment

    Usually stamped numbers on the very rear of the cam or very occasionally on the very front where the timing gear goes, not really important now the main question has been answered.
  12. R

    Probably about time-rocker adjustment

    So, now that it's all apart what's written on the back of the cam, any ID info ?
  13. R

    Lets see your cars.........

    The bars and the hood are glass, still got the mint steel hood that the mold came from.
  14. R

    Lets see your cars.........

    Hi, been a long time, Yes 15x8's, I had a set of 8" rally wheels on it but they were REALLY heavy, they had 5-1/4" backspace I think, went with the Welds but could only get them in 4.5' BS. so I cut the housing 3/4" each side and lopped the same off the ends of the axles [mosers with about 4" of...
Back
Top