Recent content by roadripper

PG classic has the linkage on sale right now ! FYI

68 dart 73 and up spindles

So i asume that with these control arms you can interchange from small to large without any fitment issues?

Hey there i bought these control arms for my dart project , the castle nut had 2 spacers under it. Not sure what the spacers are for,when installing the ball joint into the spindle the taper bottoms into the spindle but it also cuts the grease boot. So i asume that one of the spacers goes on...

Thanks for the info, will have to change the way its set up

The way it is now , i have a small pc of hose with a air line vent on it. When we fill the tank gas pours out of this vent , without putting a charcol canister up front and running a other line to front ,run it to the filler neck, car has a vented cap should work ? Not sure lol,any thoughts

Turns out its a pump issue, were gonna install an electric pump some where lol . Anyone have install pics of where they intalled their pumps? The vent at the top of the tank we are gonna runn a hose to the top of filler neck and tie into that hopefully cures a few things

Vehicle shuts off during initial warm up , cant even get it out of driveway, we changed sender last night , we have the later tank with the eec emissions that port at the top of the tank is that a vent or is that for charcoal canister ?

Car was built 2 yrs ago was a new tank and sender at that time , problably gonna pull sender and see if any issues

Son's demon has a gas tank that has a vent atthe top of the tank and the sender has 3/8"inlet , there is a second line there i beleive 5/16 "dia. Where do we hook the 5/16 line to ?or do i block it off? We are having fuel delivery issues with this car , starts and runs then stalls and then no...

So there is no factory vent lines under the car i think at one time it had the factory evac vent but don't know what to do with this line ??? if I plug it will it create a fuel delivery issue ??

We're building a 71 demon just put the new tank and sender in 3/8 line to carb , where does the other line go to ??? Any help would be great Thanks Mike

If anyone has this stripe on the hood of there car can they measure how wide the stripes are on the side of the hood ,????

Had to ask you never know

Ya I knew about the stencils, was hoping some one would have a detailed drawing so we could freehand the stripes lol