Recent content by robert 68 cuda

I'm thinking it your distributor look at the reluctor wheel really close if any have a tooth missing the other thing is make sure you have really good grounds simple test take booster cables and hook to the ground of the batteries and place on frame engine and see how it starts i had one once do...

very nice you should be in the 620-650 hp mark and torque should be in the 550-600ft- thats my guesse very nice build you might want 1/7/8 headers to make hear talk right.

i just put tti new 1/7/8 header on my mill all i can say is wow what a diffrence it made day and night diffrence well worth the money .

intake problem or valves are out of wack and whats your timing set at ???

ya 7500 is not going to be a problem iv had my 426 smallblock up to 8000 so you should have no problems just make sure your stuff is good or she will go bang hard but 7500 isnt going to be a problem for you.

well then whats the cams power band if solid you geet a little more if it is hydrolic about 200rpm befor your cam runs outyou want your car to stay in its power range.

depends on what the car is doing if its street car any wear from 5500-6500 for street and strip 6500 - 8000 pluse .

hi guys i have a 426 smallblock the problem is it stales at idle when hot like when i go into the car show it will stale after idling for like 5 min its got a qf carb 850 pulls 13inch pounds of vacume electric fuel pump pressure set at 7.5-8 psi timming set at 12 digrres 31 full in , new gaskits...

i can bump it up havent tryed it yet this is my build 426 kit cam is 600 lift air gap intale tti 1/7/8 headers qiuck fule carb comp is about closer to 11/1 i can put it up some on the ititial timing wear should i aim for 16 and up.

its electric carter pump wish i bought the new edlebrock one way quiter. it just got me stumped a bit .??? fule pressure is 7psi

all right it a 426 stroker any ways when you go to let the car idle for a while like if you were pulling into a car show it wants to stall after it idles for a while timing set a 12 degrees full in is 31 any ways cars temp is about 180 put new carb gaskets in it its got a qf carb 850 four corner...

i agree with strokerscamp if you roll on the throttle slow with the car off does it give a good shot or dribble .??holly have a lot of adjustments you can do before buying parts.

hughes wipplash cam works great to just put one in very impressed .

sorry about that stroker scamp, but it was a simple question but since none of you have any input on it the whiplash cam. It would be the way to go in a stock motor. It has got great ideal sounds like a big block worked over you dont need a stale pulls great vacuum like 16 inch pounds great...

have you guy tryed a wipplash cam from hughes just put one in and works great sound good and good power.