SlantedDart's latest activity
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Has anybody had to pop a hole in their strut tower of master cylinder clearance?? I don’t want to cut another hole in my car! Feel like... -
-
SlantedDart replied to the thread Gen3 hemi tkx swap.That’s where it’s going to sit. No speedo, my cluster makes a chatter noise so I’m taking it out.
-
SlantedDart replied to the thread Gen3 hemi tkx swap.I had a chance to model up a trans crossmember. Took a photo of underneath the car and scaled it into fusion 360. Initial model came out...
-
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Bolted right up. Holley sells right flexplate. I made my own motor mounts. Used tti measurements to mount engine
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Probably not, the old 904 was in the stock location and I just bolted the hemi to it. Crank centerline may be higher but the...
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Got the trans up in there. I’m kinda pissed I had to cut so much but it is what it is.. Lots of test fitting and wondering haha. Have to...
-
-
SlantedDart replied to the thread Gen3 hemi tkx swap.I’m hoping the run out will check out I don’t want to take those damn dowels out again.. I figured the starter support won’t hurt. It...
-
SlantedDart replied to the thread Gen3 hemi tkx swap.got everything in place. Ready to dial it in. Had to put longer dowels in. Welded in a starter snout support also. Drilled and tapped...
-
-
SlantedDart replied to the thread [FOR SALE] 8-3/4, moser axles, 741.Fixed
-
SlantedDart replied to the thread Gen3 hemi tkx swap.I’ll be putting fly wheel in and bumping the motor over before to verify. I have Ram clutch and pressure plate and fly wheel. Liberty...
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Okay. So I’ve decided to keep with the QuickTime bell housing.. First was the starter issue. I have a Dakota starter and it was working...
-
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Update.. I’m debating on getting a cast bell housing.. I’m not sure if I like the idea of not having a starter snout support along with...
-
SlantedDart replied to the thread Tkx swap guys- have questions.Man that sucks. Well I’m questioning this bell all I’ve heard it bad news with the starter not living
-
SlantedDart replied to the thread Tkx swap guys- have questions.130 tooth not sure what the actual measurement is.
-
Gen 3 hemi to tkx. I have a quick time bell RM6071 and having trouble with starter. What bell housing are you guys using? Thanks
