Recent content by supersonictoys

The engine has been sold.

Yep, only posted it an hour or so ago. A few people have called or messaged but no one has put money in my hand or Paypal account .

71 340 4 barrel steel crank HP engine complete from air filter to oil pan . This engine has been stored for 20+ years indoors. It still turns freely. Original carb. Selling as a rebuilder. These are getting hard to find. $1500 or best offer. Sacramento CA.

I have a 72 scamp street car, 3300lbs. Did a 360 magnum to 408 stroker with 10 1/2 to 1 and unported eddy rpm heads. Its a hydraulic roller with roller rockers and 750 cfm quick fuel carb. With 391 gears and a 3000 stall converter the car runs consistent 11.70's on pump gas with no ping at all...

This is what it says on summit racing about the Milodon cover... Description: Swap out your leaky stock timing chain cover with one of these stylish, high-quality Milodon steel timing covers. Each cover is precision-checked for the proper placement of the seal and dowel pins to avoid leaks and...

Well I read that the mild on cover is 90 thousands thick and will not flex. I ordered one so we will see when it gets here tomorrow. As for my fine threaded cam gear bolt holes, it doesn't really matter because I'm sending the piece of **** back. Ordered 114 lobe center and after we degreed it...

So I have a 500 inch 440 in a 65 dart tube chassis car and it was a mild supercharged build with eddy rpm heads and a fairly small solid flat tappet cam and I'm in the middle of converting it to a hotter build with Victor maxwedge cnc ported heads and a big solid ROLLER cam. I thought I had...

Nice matched pair of dual 1150cfm dominator carbs that were run together on a blown big block. I never ran these but bought the intake setup and a lot of parts from the widow of the previous owner. These are not boost referenced and a strait drag carburetor. These are setup for gas and were only...

Real nice pair of 850cfm double pumper carbs with 4 corner idle, 50cc rear pumps, and boost referenced power valves. These come complete with stainless side saddle fuel lines and holley fuel regulator with gauge. These are super clean and ready to bolt on and run. They came off my own car 7 days...

Heads have been sold.

Like new pair of edelbrock performer RPM aluminum heads with 27 passes on them since new. The also come with Harland sharp aluminum roller rockers and shafts, heavy duty pushrods for flat tappet cam and ARP pro series head head stud kit. These heads we put on my motor a couple years ago but it's...

15 mid 9 second passes and it needs to be freshened? I could see it if it had a few hundred passes. It was just freshened up and it tight like new still. As for what's in it, I'm not interested in taking it to a tranny shop and paying to have it torn down just to see what's in it. It's fresh...

No one? Found the receipt for the ATI converter.

No idea, never had it apart. The guy I bought the car from told me it's a houghes racing tranny but I have no way to verify. I do know that it was behind an 871 blown 505 inch motor and was holding up fine.

Perfect working full race manual valve body 727 torqueflite for big block Mopar with Turbo action pro series Trans brake. Comes with 9 1/2 inch ATI Tree Master Fuel/Blown anti ballooning 3500 stall converter, 440 source internally ballanced SFI flexplate and super heavy duty converter bolts, CSI...