Recent content by Thenwhat85

hello all does anyone know if nick jr took over for nick wilson at compuflow? just read a forum im not a member of about him possibly being open. the post was dated late 2018. i dont have a number to try and call anymore. lost it with my old phone.

yeah i think thats the route im going. i like the light pistons i was just curious if they would stick out the bottom bore too much and rock excessively at bdc

i have a stock dakota starter from car quest, 3 years strong so far. turns my 440 over with 12.5 compression. i did raise the timing this year to 38 and its struggles when the motors hot

I like my promaxx heads almost 4 seasons no issues. But im eyeing up the 270s cause theyll make more power on a new build im planning. Bang for buck from what im reading the trickfliws are real nice. If you already got heads though and its a mostly street car i dont think me personally would...

i have a torker 2 that would be a better option for you. also its tought to figure some things out. cam grinders want converter, gears, weight, power, torque, etc and then converter builders need all about the same and the cam. so what comes first the chicken or the egg

No expert here but i think your cams a little much for a dual plane and your combo in general. Depending on your weight you could be in the 10s. I run 9.60s at 2700 with a 440 .030 over 12.5 and a 255 @ .050 .618 solid roller. Promaxx heads mw ports with just casting cleaned up. And an indy...

9.63 at 138

mopar hunter im interested your in box is full any other way i can contact you

Heres a valve

yeah i had them machine the heads to 75cc install stiffer springs for my solid roller cam. i did take them apart and check them out. im no expert but valve hights were all with in a few thousands. the valves have edelbrocl engraved on them, i did swap out retainers and locks cause i had some...

Will do going to be a slow build due to funds but its definitely getting built

check out promaxx as well i have an old set before they had the cnc program made for them

well i found diamond pistons with a 1.305 ch so that puts me .015 in the hole on 9.98 deck with the 4.25 stroke 6.535 rod. think this is the route im going to take granted the block doesnt need decked alot

yeah but how much typically needs taken off to square the deck? i know it varies im not reasy to take to machine shop yet still in the planning stages