Looked into them it’s an option, how ever I’m goin to be thorough and finish what I started. I am attaching a pin out I’m stuck on pin 3 and 4 ? Why is there so many things going to 1 pin
Ok pins 3 n 4 on the brake pedal I could use a little guidance this is what I see pin 3 says fused ignition
Ground
Speed control switch
output
Pin 4 says I goes to c3 pin7 and c3 pin 14?
Where do you buy your harnesses? I’m open to options but this was a pricey harness so hopefully I can work it out as well as solve an issue that I have seen go unsolved, ls has all the support in the world I’m just trying to solve my pedal issue and share my results with the abody/hemi community...
Oe gas pedal from a part out,
however I just got my brake sensor and pulled up a pin out and it has speed control signals. Etc the 05 ram brake pedal switch so my last hope is that it needed the brake sensor from ram, current set up is only a body side switch for stop lights
I’m looking for...
Do you have other tuning software where you can send me a data log and tune file or I can send my hp tuners to you and you simply scan and send if not it’s cool it’s asking a lot but I’m about to spend on a new harness Hotwire auto said they are very sorry and know the harness swap specialties...
I have only 3 fault codes
Fans
Air temp circuit high
Bank 1 circuit high
I have the codes written down if you think those can be it
On hp tuners I just don’t read mph so I ordered a new brake switch I was using the doge dart one and may be missing inputs? How many pins do you use all of them...
05 pcm
Thank you for checking @loganscuda another question what is the consensus on the brake switch-stock ram or stock dart?
Other than that I cannot figure out why I’m only missing mph and pedal cut out, the car is damn near race ready maybe a new harness
Ok I’ll do what I can on my end till then I’m betting that’s it, if so the real question would be what does that wire see as bypass; voltage, ground, modified signal, etc.
Good luck with the renovations sorry about the damage to the house
What about c3 pin #5 speed control vacuum vent solenoid are you guys running that part? My speed system is solely 2 speed sensors on the trans where in theory I have 0 speed control inputs?
I’m not with the car I gotta scan it and update for the 4th pin on ecu too
I’m really trying to make pulls with his car so I wanna be able to slam that pedal
I know that my hp tuners doesnt catch my mph