Recent content by voodoo1

Man I was gonna comment and say, you guys ***** more than a guy complaining about a Chevy motor in a Ford... But all is good. Haha Merry Christmas to all you guys. Mike

Setting the timing helps the motor run properly. Set the timing, play with the idle. sometime back and forth. Get a tach on it so it gets the correct idle speed. Mike

Paid in full! Thank you Rich. See you next weekend when you pick it up. Mike. Thanks FABO for ad space!

What did you use for spring mounts? Did you use adapters on the front wheels? Mike

Parts car for sure.

Thank you!. Sale Pending to nwdart

Ok I hate to do it but I need to make room. 1972 Dart Project. This was going to be a strip car. I put in Through the floor sub frame connectors. I used 2x3 tubing. Welded up the K member and put a 1/8 plate with tow hook. Widened rear tubs. Moved rear springs in with the spring kit. I...

Couple telephone books! J/K. Of course that can be done. Not too hard either. Do you have a welder any fab skills? If not pull the seat out, take some measurements Figure out how much higher you need. Talk to your local upholster guy, he might know someone who could do it for you. Mike

So with the previa rotor and caliper you're set. That's cheap.

Looks good. How much do you have into it? Mike

i'm liking this one a lot. Let us know how you do this weekend. Mike

What plug?

I see your point in what you're saying. I'm looking for experience from people who have done this. Just because it blows up doesn't mean failure. Junk yard motors are cheap. I'm certainly not talking about putting a maximum shot first time out either. I just think it'd be a cool experiment.

Just curious cause I might do it. What is the biggest shot possible for a 318 roller motor. Totally stock motor, cam heads. Put a M1 intake or something similar and how big of a carb would you need for it. Would convertor matter and or help? Car would be a 72 Dart. I'm talking total drag car...

Put the stands under the frame, where it's solid. No you don't need to loosen torsin bars. You need upper A arm from that disc brake car. Along with the spindle. Good idea to replace the upper ball joint since it's already out. I've heard of using the old dist block, might be better to grab it...