Recent content by VV1-P

Thanks for the heads up. I just cleaned it out.

Does anyone in So Cal have an early a-body drive shaft? The Ball and Trunnion type for the 106" wheel based cars? Parts book says the same for /6 and 273. Also same for 3sp, 4sp, and AT. Not the same as Dart non-wagon since they are 111" wheel base. Not the same on '66 up since they went to the...

Looking for the pin that the throttle cable attaches to and the wire mount that clips on the air horn for the air cleaner. This is for a super six bbd (slant 6 2bbl) but maybe the same as the bbd on a 318? See pics. Any help is appreciated.

Thanks Dave. PM sent.

Please do. I appreciate any help I can get with these.

Congrats! Love my '64 Valiant!

The bezel of my driver's side is damaged and water is getting in messing the lock up. My ignition and passenger's side are both working perfectly.

'61 to '65, driver's side is the one I need. No key necessary, I will have it re-keyed. Just need one with a nice bezel and such. Anyone have a good used one they do not need?

Your casting number is for the '68 to '75 5 freeze plug RG 225 block. There should be a number faintly stamped on the passenger's side front of the block, facing up, under the alternator bracket where the head meets the block. It is kind of hard to locate until you know where to look. This will...

The gearshift cable is separate from the park lock cable. The 1965 Transmission Parking Lock Cable for A-Body without center console is part no. 2460552 (Same as 1965 C Body). The 1965 Gearshift Control Cable for A-Body without center console is part no. 2534413 (same as 1965 B Body). Hopefully...

Slant 6 for sale

I have a '64 Valiant Slant 6 and am very happy with the suspension for a daily driver. 1" Just Suspension torsion bars, Edelbrock IAS shocks (NLA), all poly bushings and bump stops except the lower control arm bushings and the steering struts bushings (I used moog at those locations), Hellwig...

Any '64 Valiant rear deck finish panels? Between the taillights, hole for the trunk lock right in the middle of it.

Found! Thanks FABO!

Pre-'67 Slants won't work with a 67 up auto tranny as far as I know (unless you change the crankshaft to a 67 up crank). You will want to get a 67 up Slant to work in your 72. There is one in So Cal from a 72 Dart in Craigslist right now for $300 (Slant 6 for sale). Maybe get it for much less if...