I have a 68 Barracuda that I have tied up all the unibody/floors and tubbed the rear wheel wells. I'm installing a RMS front suspension, 6.4 Hemi, Tremec 6 speed trans, Cal-tracs and a shortened Dana rear axle.
I'm Looking for any recommendations for fit and quality to put a 6 point roll bar...
Thanks everyone for your photos!! Thanks Curt for showing your Mods because the 6.4 Manifold is higher making the wipers a problem and You keeping it and showing me your modifications to do so is awesome. Also even though I'm using an updated wire harness, I wanted to know If I could still use...
Thanks Craig, but I'm looking for the front firewall changes for the 6.4 engine fits, wiring harness, wiper hole mods. My Floor has already been modified as I'm installing the same Tremec Trans. Thanks!
I'm looking for any photos on changes people have done to their A-body firewalls to install a Gen 3 6.4 Hemi. I'm installing a new crate motor in my 68 Barracuda and I have an idea on the modifications needed but would like to see what others have done. Thanks again for any Help.
looking for help! I'm installing a 6.4 Gen 3 and a Tremec T56 gm Magnum 6 speed and I've run into a Pilot bearing Issue. I got a adapter setup roller bearing from American Powertrain ( https://americanpowertrain.com/shop/accessories/pilot-bearing-gen-3-hemi-to-gm-tko-and-magnum-1-33-od-60-id/)...
Here is a pair of Exhaust manifolds off a 1968 Barracuda 383 casting number #2946729 is dated 6-22-68 and casting #2863900 is dated 1-18-68.
Original big block exhaust manifolds, bead blasted and painted with 1500 degree VHT.
I will be selling quite a few 68 Barracuda parts in the near future...