Recent content by WCMachine

Car year and model 74 Duster Front Wheel Brand weld Size 15x4 Backspacing 1.87 tire size 26x7.50 Suspension mods QA1 arms .93 bars Rear Wheel Brand weld Size 15x15 Backspacing 7.5 tire size 33x21.5 Suspension mod full frame and tub

im looking at new wheels for the duster. Anyone have this combination? Weld star bead lock rear with s71 front.

Also, If i lean out the idle mixture to get max vacume. It will not idle reliably in gear. It wants a richer idle mixture in gear.

I have been trying to lean out my cruise mixture. Specs are AED 950HO, super victor, performer heads, cam= 234 in 238 ex .571” in .576 ex, 410 magnum. 18 degrees timing at 1000 rpm idle. I am running around 10.5 AFR at cruise rpm 2500-2800 @ 40-45 mph level ground. AED suggested increasing the...

This post was from last year. It’s on the 16th this year

ARP head bolts for magnum with Edelbrock heads. I decided to go with studs instead but to much time has passed to send these back. The kit is new and compleate. $75 shipped PayPal F&F or you pay the fee. PM if interested.

up for sale is a basicly new air gap manifold. It’s never been installed but some of the bosses I was not going to use have been milled down. Has some aluminum pipe plugs installed. $260 shipped, PayPal FF. Ships in original box.

I removed this 1970 340 from my 74’ Duster last fall to install a 410 stroker. It ran well when removed and did not burn any oil. It has a cam and performer intake. I do not know anything else about the internals or what the cam is. I feel if it had new gaskets and paint it would make a nice...

No, the magnum and LA filter plates are not the same. Canton still makes one for the LA it’s part number 22-575

is there any interest in a Billet aluminum oil filter plate with an O ring for the magnum engines? I reached out to canton about their 22-575m and was informed it was discontinued. I have decided to make a few and im trying to decide how many. Anyone interested, no commitments just curious.

Any one try these PRW 4036007 magnum valve covers. They look nice but I’m not sure what the notches on each end are for. Why not just make them symmetrical?

It’s a 3” collector. Flanges are only about 1/4” thick

Can’t find any numbers on mine

Does anyone recognize this small block header? Kinda looks like hooker.