I'm rebuilding a 518 trans and need a replacement 6" 12 roller removable race low reverse drum. Can't find one new or used only the 14 roller type.
The drum from a 727 fits and the dimensions appear to be the same other the it's longer at the support so the washer and snap ring don"t fit.
The...
I had the same problem with my duster . 440 with 2" tti header AR-Engineering motor plate . The headers hit the manual steering box and both torsion bars. Had to dint the header for clearance.
On the top of the ps box there is a plate that has oil lines going into it. That plate is your adjustment. With car safely supported with front wheels off of the ground start the engine. If the wheel turns one way or the other on its own you need to adjust. The procedure is easy, loosen the...
The bath tub gasket will not work with the indy heads.
You will need to machine the intake manifold , modify the valley plate, or go with a single plane manifold.
I'm running the 2" tti header and the may have 1/16" from the inner fender.
There no room to move the engine as the headers with contact the t bar in my case.
Running 440 with indy EZ heads and a motor plate
If it was crankcase pressure it would be leaking oil everywhere, not just past the intake gaskets and or valve seals.
The pcv system does nothing at WOT when crankcase pressure is at it's highest and little to no manifold vacuum.
You don't need a pcv system just adequate ventilation .
Sorry...