Any good pics of cheapy universal style mopar headers?

I had a set of the flowtechs on My 72' Dart .I'm still Debating whether to re-use them when I install the new engine .Overall quality was fairly good for the price.The ceramic coating held up well.The issue I had was with My larger than stock torsion bars one tube on the pass side had to be dimpled to clear. With stock t-bars I don't think this would be an issue.Installing them like any headers is a lot of work I removed the t-bars raised the front-end up significantly and used my engine hoist to lift the engine for additional clearance.Also you have to partially disconect the steering linkage that goes through the tubes on the D/S.I'd advise you to invest in some good gaskets that's the one issue that drove me nuts like all cheap headers the flanges are inconsistant and the ports don't match up correctly creating leaks.If I reuse mine I will probably cut the connecting piece in between the front/middle/rear tubes. To hopefully allow better sealing.And maybe try those thick,soft aluminum gaskets.The only other issue was the steering shaft u-joint scraing against the header tube. I wound up replacing it with a flaming river piece for more clearance.