Small block Harland Sharp roller rockers, shafts and hold downs

One more thing I learned from this deal. Since this metal had to go somewhere, I decided to pull #8 rod cap. I had already done the old "side to side" movement test, and they all appeared to be fine.

Sure enough, #8 rod bearing had lost its tension, was down to the copper, and it would not have been long until it spun. I think the good H-Beam rods helped keep it from happening.

#7 looked just fine, but the rear main obviously had a little crap go through it.

I was going to list this stroker motor for sale next, but now I am going to take the crank in and have it checked to see if it needs turned.

Not sure what I am going to do now, but love looking at these pieces, they sure are pretty.