Grenaded the rear end in the Cuda! BIG TIME

Billet main caps are from Mark Williams ONLY! Trust me. THey are about $75 each and they need to be milled to fit by a machine shop to do it right, as they come about .010" large on purpose. The caps fit all 8 3/4 pumpkins.

Other than that, if you use a 489 case, get a solid pinion spacer. Sure grips will work just fine...no need for a spool.

I would also back brace the housing if you can. Mancini sells a brace for about $60 and then you need to weld it on. Don't listen to people that say you can't weld it on w/o taking the ends off due to heat warpage. Those people are just passing on bad info, as I'm sure they've never DONE it.

If you weld it on, just weld small 1/2 long sections at a time and move all around. I did mine and it was EXACTLY as straight as it was before I started. I measured with a Lazer level on a wall about 20' away, before and after.

Other than strong axles, that's it. Should be strong now!