Small block Harland Sharp roller rockers, shafts and hold downs

ED,that little bit of wear wouldn't worry me. I have seen allot worse on some dirt track motors..I like to run 3 to 5thos.between them.and I also run 3 on the bearings but I run 40or50wt. the motor I was putting together the boy bought a new set. if I had the extra cash I would buy them. I like dealing with people like you theres not to many honest people around any more... thanks Artie

Thanks Artie, life is too short to burn bridges with people. I truly appreciate everyone's nice comments, and felt like a total idiot inconveniencing Greg on this deal. He took his lunch time, and picked up a money order and got it mailed off.

I think you are right about the clearance, and make a great point. I remember now setting these up so that they were dead on, lined up with the push rod hole/valve stem, the best I could.
This is the first time I had the HS shims and hold downs, as I just used modified stock stuff, with my race motor years ago.