centre consol makeover!!!
hi there, i did my dash, see post "now ive started somthing" that involved retrimming dash pads in same material,the best advive can give is: get your area to work in clear< sounds daft but you be surprised how much glue drips out hot glu gun, get plenty of glue sticks, i mean plenty! sharp utility knife/scissors,more material than needed, tip, i didnt put any glue on surfaces you can see,it causes bulges.... the glue was run in 6" lines on edge you cannot see ie undernearth or other side.more than 6" the glu cools and you cannot work it as goes off, hold for 30 seconds and work your way down DONT DO OPPOSITE yet.clamps {see pic}handy get used to burning your fingers as glue ooses out as you press{ cuss if you must,i just imagined how good itll look, that got me thro pain barrier:cheers:once you worked one complete side do opposite pulling tight as you can,stuff i used pvc based and quite stretchy,tip 2 as with my dash trimming there were awkard bits where creases inevitable,i actually put hot glu under these and made the materail even more stretchy with heat and pushed tite into corners,,just take your time really and please keep us updated!
hi there, i did my dash, see post "now ive started somthing" that involved retrimming dash pads in same material,the best advive can give is: get your area to work in clear< sounds daft but you be surprised how much glue drips out hot glu gun, get plenty of glue sticks, i mean plenty! sharp utility knife/scissors,more material than needed, tip, i didnt put any glue on surfaces you can see,it causes bulges.... the glue was run in 6" lines on edge you cannot see ie undernearth or other side.more than 6" the glu cools and you cannot work it as goes off, hold for 30 seconds and work your way down DONT DO OPPOSITE yet.clamps {see pic}handy get used to burning your fingers as glue ooses out as you press{ cuss if you must,i just imagined how good itll look, that got me thro pain barrier:cheers:once you worked one complete side do opposite pulling tight as you can,stuff i used pvc based and quite stretchy,tip 2 as with my dash trimming there were awkard bits where creases inevitable,i actually put hot glu under these and made the materail even more stretchy with heat and pushed tite into corners,,just take your time really and please keep us updated!