EZ wire harness.

#1. How do I wire the ignition. The ez wire kit has 1 wire that says coil +
I am running the factory mopar electronic ignition.

you have to find the two wires from the ign switch. one will power up in start position the other will power up in run position... the start position wire basically goes to the side of the ballast resistor that goes right to the coil. the run position wire goes to the side of the balast so power willpass through the ballast while the key is in run position... does that make sense?

#2. How do I wire my door switch so that the dome light comes on when i open the door,and when I turn the dimmer switch all the way on?

thats a little more tricky. we changed mine around so it switchs ground instead od 12v.

#3. The alternator wiring has a charge wire and alternator exciter wire. What goes were and how does that plug into the voltage regulator?

what regulator you running? for a dual fld ya run the one fld wire right to the regulator. the other fld wire goes to the other regulator wire but also runs to the key (run position) side of the ballast...

here scroll down the page to the dart section... http://www.automotiverewire.com/Navagation/documents.htm