Anybody running 17" Cobra Bullit rims on a Duster

You could go ugly and use a sandpaper roll in a drill to open the holes up. I did that with my "test" wheel and it took about 10-15 minutes being careful to open it up just enough. I think it was like $75 to take my wheels to a machine shop and have them bore the centers out to hub-centric. If I had been smarter at the time, I would have had them go out to 73mm (or whatever the common largest-hub-ring-size is) and use hub rings to center the wheel.

It adds cost to the project, but these OEM Phord wheels are well made and common.

Clair