Help with bucket install...help !!!

Hi,

I bought a set of non mopar buckets for safety even though I had a set or originals to restore and install.

I assumed that it could attach the new buckets to the existing sliders and bob would be your uncle.

Anyway, by eyeballing the mopar sliders in the car, they didn't look flat so we put a level on them an they were not,,btw, I labeled them when I took them off...so I dug out the original seat frames..also marked....bolted a set of tracks on them..no go..so I reversed then and three out of 4 holes work but it is silly to look at.(see picture) .the slider control should be on the door side..and btw, they are very close to the door.

I guess it would have been too much to ask for a flat install like other cars I have worked on..

do I have the wrong sliders ??? does anyone have a template that I can make these seat fit ?

Thanks
Ian.