67 Dart Build Triangulated 4 link & Mini Tub

I didn't cut the rear end down I left it uncut and I'm not using a 8.75 I'm using a 9.25 out of a 1979 Ramcharger it was 65" flange to flange. I measured my flange points in relation to the axle in the car and the relationship of the wheel to the quarters and inner fenders. dropped a plumb bob and marked the floor But I made sure before I cut a thing that the flanges would end up where trhey needed to be and that my Pinion was where is needed to be. (been doing this stuff for 13+ years) NI just noticed that my lower arms are at different locations and thats based off of the frame rails being offset in the car for some starnge reason.