72 duster Build progress

somewhere i may have missed it, but what are the seats out of? im about to do some to my duster, and like the looks of yours. also, what were youre measurements on the risers?

thanks
Michael

The seats were out of ( I BELIVE ) a 2009 accura TL type S , I lucked out and found the set for $100.00 ....but I can't say the same deal could be found again lol.

the seats are about 4" over all wider than factory buckets would be ...so there was no way of mounting them to the flat part of the floor pan, so I utilised the factory bench mounts on both sides....but in doing so , I had to make risers to keep the seat at level height all the way around.

on the front right passenger side corner I used no riser, front left drivers side corner I used no riser, front left passenger side I used a 2 1/4" riser angled to the degree of the track and same thing on the drivers side, and then on both rears of the seats I used half inch risers.

I of course had to use bolts to match the lengths of each riser which was no big deal.

It wasnt a HARD job by any means but I hope you have a good back because I had the seats in and out of the car a TON of times lol.

hope that helps and if you have any more questions about it, just ask.