edelbrock cylinder heads

Patiently waiting for the normal pissing match to start.

Allways the case with such questions. Carbs, *** hats, etc....

The talks I've had with a few people, we seem to think the RHS heads would work really well on smaller CI mills for a few reasons.

This is where I was going with it, to a degree. The slightly smaller runners and I beileve the 1.94 valve size is great for a 318 street striper. Not bad for a larger street machine at all.

The Edelbrock with the larger runner lends itself to a good spec read out for a larger engine in a street strip duty application. Ported out, it should well support 550hp and more without getting crazy on the engine. Then again, crazy is an opinion and point of veiw now isn't it?

After the Edelbrock heads, the choices get even more expensive. Brodix, INDY's, not exactly a street head now.