Jeep rear discs on an 8 3/4 axle solution

Moles,
close but these are really on a 8 3/4" rear.
Here is what's new.
The machine shop wanted $150 to make some spacers for the set up.
I went and got a set of bearings at O Reilly and cut the races and inner cores down to 5/16" with a 4" grinder and thin metal cutting discs using the actual Jeep backing plate as the jig. I laid the disc on the plate and cut through the race as I turned it. After I was done I miced the pieces and again using the backing plates I final dressed them until they were the right thickness.
Now I have the final pieces of the puzzle to assemble the system.
Andrew