built a 408 small block. supercharger options?

schultec14 said
Hi, I recently built a 408 stroker engine for my '70 dodge dart. It has 9.5:1 compression, comp cams xe275hl camshaft, pocket ported J heads with 2.02's. and 1.60's, edelbrock performer rpm air gap single 4 barrel dual plane intake with an edelbrock 750 carb, headers and dual exhaust. I would like to know what my options are for bolting a supercharger on this car are. Im still looking to keep it on high octane pump gas though. I was thinking of a range or 5-7 psi of boost or so. What kind of prices am i looking at for a complete setup? Could i find a site that has used ones for sale? (Also as a side note, any chevy people?...My friend wants to find one for his carbureted '69 corvette 350 engine, which has a very similar build. preferably used but good.)

Thank you,
-ANTHONY

The compression is not too high. You need to run some type of cooling system to keep the air charge as cool as possible. Also check into an AIS Water/Meth Kit. Call them, the owner will explain everything to you and set you up to run with no problems.

I myself am building a TT 410 Stroker right now with 9:1 Compression and will be using 2 air water intercoolers, a heat exchanger with 2 10" fans and an AIS Stage 2 Meth kit with probably 3 Nozzles. 1 in each intercooler and one right before the carb! YES it will be ran on Pump Fuel with a Boost level at around 15PSI Max.

My Build here:

http://www.forabodiesonly.com/mopar/showthread.php?t=116512

You can check out the AIS information page here...........Very Inexpensive to set this kit up.

http://www.alcoholinjectionsystems.com/index.html