A tale of two Dusters
Great News! I now have solidworks on my laptop so I can work on parts designs at home. Such as, My 3D Subframe connectors!
Like this:
Basically you have a upper(inside) piece, and a lower(outside) that sandwich the floor and bolt together. So you can have a backbone type subframe connector for torsional rigidity and not have to hack the floors. This isn't quite finished. I have to add the pieces that will go the the rear frame, and the firewall (to connect to the front support) but this is the general idea. It isn't actually as intrusive on the interior space as you would think. About the same size as a center consol, and you could finish it as such if you wanted.
That is about it. Thanks again for following my projects.
Great News! I now have solidworks on my laptop so I can work on parts designs at home. Such as, My 3D Subframe connectors!
Like this:
Basically you have a upper(inside) piece, and a lower(outside) that sandwich the floor and bolt together. So you can have a backbone type subframe connector for torsional rigidity and not have to hack the floors. This isn't quite finished. I have to add the pieces that will go the the rear frame, and the firewall (to connect to the front support) but this is the general idea. It isn't actually as intrusive on the interior space as you would think. About the same size as a center consol, and you could finish it as such if you wanted.
That is about it. Thanks again for following my projects.