360 Rebuild

My bllock was allready bored and clean. So machine prices are per your machinest.
Otherwise, I got my short block done for abot $1250. I have everything else to finish it up with.
My last, just recently finished 360 was redone with ;

(Prices rounded off and approx;) )
KB-107+030 slugs $210 http://www.summitracing.com/parts/UEM-KB107-030/ (or http://www.summitracing.com/parts/TRW-8KH116CP30/ with rings)
Con Rods upgraded and cheaper than re-doind OE rods. Egale @ $500 http://www.summitracing.com/parts/ESP-6123C3D/
Moly rings under $38 http://www.summitracing.com/parts/SLP-E-251K30/
Bearings under $50 $4.50 X 8 = $40 http://www.summitracing.com/parts/CLE-CB481P/
oil pump $25 http://www.summitracing.com/parts/SLP-224-4166/
I also did my own cam bearings. I have the tool.

The balancing job with flywheel resurfacing was $345.

A complete cam shaft kit is a great deal like set ups from Comp Cams. Like this one; http://www.summitracing.com/parts/CCA-K20-223-3/

A MP gasket kit is a great money saver that will include more than you need and everything possible. Add a few bucks for small things and a few oil/fuel filters.

The total here so far is under $1500. No machine work included.