bucket seat help

don't waste your money on prefabed floor supports just go buy a strip of steel thats about the width you need it and cut it to length and drill your own holes, I'm sure it is cheaper that way. I would HIGHLY suggest getting a framer's square because the dimples they make are not exactly true in squareness so if you just go off one dimple and assume the other dimple xx inches away is directly in line then your seat may be twisted or holes be off. What I did a few weeks ago for my bucket seat installation was drill the dimples that were next to the floor hump then used the framing square with the flat edge against where the door comes up to the body on the floor because it's very straight and marked off the distance that I measured between studs on the seats.