Project Plain Jane
Hi again folks! Caliper is soaking as I type. I JUSt put them into a container and poured in the evaporust! % gallon pail was too tight so I used a small plastic beta fish tank that isnt used for anything now. I could start to see results in 5 minutes!!! Large patches of rust were turning grey.
I completely disassembled them. Bleeder screw etc were very easy to remove after a long soak in solvent,didnt need force or heat.
I'll let them soak for 2 hours and check! Rinsing is the only step needed after that.
The second caliper is in the solvent tank and I'll pull it out when this one is clean and ready. Paint will be VHT hi temp caliper paint in red with a coat of primer first!
I'll need to chuck the bolts etc in too.
5 gallon pail isnt quite wide enough!
Fits much better in this old beta tank!
Hi again folks! Caliper is soaking as I type. I JUSt put them into a container and poured in the evaporust! % gallon pail was too tight so I used a small plastic beta fish tank that isnt used for anything now. I could start to see results in 5 minutes!!! Large patches of rust were turning grey.
I completely disassembled them. Bleeder screw etc were very easy to remove after a long soak in solvent,didnt need force or heat.
I'll let them soak for 2 hours and check! Rinsing is the only step needed after that.
The second caliper is in the solvent tank and I'll pull it out when this one is clean and ready. Paint will be VHT hi temp caliper paint in red with a coat of primer first!
I'll need to chuck the bolts etc in too.
5 gallon pail isnt quite wide enough!Fits much better in this old beta tank!