Here are some pics of the new intake with the EFI Bungs. The measurements on Edelbrock's site are incorrect for this manifold. The Throttle Body Elbow will not work at all. It sticks WAY past the hood line.
I am so pissed that the elbow is going back to Summit and I will be fabbing up my own intake elbow so it will clear the hood for sure when I am done.
I am going to pick up an Aluminum Carb Spacer or some 1/2" aluminum stock and make one out of Sheet Aluminum or some round aluminum elbow material that I found. I already have the flange for the Throttle Body that came with it in the Box which is good at least................
I will need to order a few more AN Fittings to finish off the fuel rails. Those fit perfect and should work out well. I will be using a 45* fitting so the fuel pressure gauge will not interfere with the valve cover on the passenger side.
The TPS is finally mounted and I needed to drill and tap 3 holes to make it work. 2 in the aluminum mounting pad of the throttle body and 1 in the shaft to clock the TPS but at least it is done!