pitman arm off drag link Help????

on the upper joint...you would want to place the chisel againt the out side [hexed part] of the joint and hit it like you are unscrewing it...cause thats what you're trying to do-unscrew it.

the lower, you go between -spindle/joint knuckle 'at an angle' so you don't hit the pin/stud and chisel on the knuckle itself.

Me?
I have done this 2 ways for last 12 years, and thats to use the remover from autozone that I posted a pic of, on the lower joint. BUT 1ST I use a dead blow hammer with the lower/upper still tied together, you swing it up to the under side of the upper arm.. This way u r using the torsion bar to assist/pull down/away from the arm-always have a block/jack about an inch or 2 under the lower, so that when it snaps down....it doesn't smack the ground,you or anything else.