Brake pedal is really stiff

I basically wasted my entire day yesterday. I woke up early and took the master cylinder out. Broke my ratchet getting it out. Bled it on the bench and reinstalled it. Checked and bled the rear drums. Broke my small ratchet on one of the rear drums. Checked the RF brake and repacked with grease. Broke the bleeder screw on the brake cylinder. Went and got a new bleeder screw and installed it (took forever to get that little brake line in between the rubber line and the brake cylinder back in). All the rubber lines look nearly new btw. Took the tire off the LF. Broke my adapter on my impact wrench. Bled that brake and took it out for a ride. Nothing at all changed....I was so pissed I could have driven the car off a cliff. 2 broken ratchets, a broken adapter, broken brake cylinder and 8 hours of work that went for nothing. Brake pedal still only goes down a couple inches and it's really hard to stop because you can't keep applying pressure after that to stop quicker. You really have to mash on the brake if you want it to stop faster.

I'm not sure what kind of master clyinder it is. It's the type that has a bolt holding the cover on, rather than the bar that clips across the top. I also have what looks like a brand new brake booster. Should I install this or just go and get another master cylinder?