Deep sump Pan

JR said
Looks great.

Have you thought about taking a rear sump truck pan, cutting off the sump and welding it onto a car pan? Just a thought, they are pretty deep and I would think that they would match up.

no i have not... i dont think there is enough clearance between the center link and the pan for that...

madmax/6 said
Looking good but i did spot that the angle is wrong,just measure from your cut on the pan.Think the angle is 30 degrees.Took me two pans to get it right.My first one was soo bad I would have to say it was the worst thing I ever built.These pans with the angle are very hard to modify and make look good.Mark

yea... i set the pan bottom on the new sump sides and i went... thats not right...

so 30* i can do that! thanks madmax!