need help with installing electronic ignition

340plot said
ok. the 72 duster i am working on had points ignition. so i installed my msd box. but stupid me, when i hooked up my toggle switch under the dash, i put the wires on wrong. so i fired my msd.
now i have a old harness that is electronic ignition. but alot of ends are hacked off, so i want to use the section out of it to run electronic ign.

i have the harness, the ecu, volt reg.

i printed out a picture that a-bodyjoe had listed on here for another member, but it is for a hot rod.

does anyone have the conversion instructions that comes with the kit from m.p?

doesn't matter if its for a hot rod.. its all the same basics.

it comes down to two wires for the most part.

blue with yellow tracer goes to the key (run) side of the ballast.
black with yellow tracer goes to -coil.
green with red tracer is not used.

the others are obvious where they plug in. only way i can make it any easier for ya is to come install it myself...lol