TTI Exhaust on Early A's

I put a 2 1/2" tti system in my 64 Barracuda. I ended up basicly starting at both ends and finishing up with the center H pipe, I think I had to cut 7" from the rear of the H pipe.
I have original engine brackets and OEM insulators but couldn't get my engine to the centerline dimension that tti gives as correct location.
I have a 904 and used my manifolds, the pass side front pipe wouldn't fit. I had to trim the pass side trans/engine brace with a hacksaw to clear the pipe. I also used a BFH on that pipe to get some clearance at the pass torsion bar.
The park brake cables I left in place after cuting off one guide - they just lay on top of the pipes.
Hacksaw also took care of the oil filter mount bolt.
I like the tti pipes better than a set I had installed on my 65 by an exhaust shop.