Any ideas on rear shocks?

Here's what I came up with for now. Hopefully the pictures aren't too bad or hard to make out. I just welded a piece of angle iron at the very bottom corner of the stock isolator box setup. The angle iron piece is probably about 1.5 to 2 inches long. For the mount bolt I think I used a 5/8" bolt with a sleeve over it that the shock mounts on. Unfortunately the sleeve doesn't fit as tight as I wanted, so I wrapped an innertube around the bolt and jammed the sleeve over it. The local parts store sells shock mount bolts (as well as Mancini, but I think the Mancini ones were pretty pricey), so that would probably be the easier route. The only other thing I did was take the top plate of the isolator setup and swap sides so that the original bayonet style mount was on the front of the new setup so it wouldn't get in the way of the new shocks.