Update on My 64 Dart project

Sorry guys for not updating lately, been busier that a one legged man at an *** kickin contest!!! I have not made much progress lately, waiting for a metering block to finish the plumbing from the master cylinder to the linelock. I now have the bare block, bell housing tranny case and tailshaft to start mockup of the headers, starter and insure adequete clearance for the brake lines. I also now have the braided caliper to hard lines so i'll be able to button up that portion. I need to figure out how the window trim goes back in so I can replace the glass and gaskets. Any help there would greatly be appriciated. I'm still trying to determine if i need to notch the K member to clear the Milodon pan. Oh, I also POR 15'd the floor pans. Note to self, wear rubber gloves next time.