Cuda Capers: 1-27-07
Nothing much to report here... Progress was being made, but at a slower pace. The guy who's doing my car has been swamped with work (his lot was FULL today, plus inside the shop...) but he promises it won't be too long before it'll be done.
I can't wait.
The trunk lid is almost done, although it was nice to begin with...
The lower right edge of the body line is whacked right on the crease and under both tail lights are dents from where the rear bumper was drilled into the quarters at one time in my car's past. This was all cleverly hidden with a HUGE application of Bondo....
Here's the drivers side being pulled. The entire rear valance is seperated from the quarter panel. He's not sure if it'll be easier to just graft in the areas from the quarter panel skins I brought out to him. I left before he made a decision.
Next week I'll run out there and see where we're at. Updates to follow.
Nothing much to report here... Progress was being made, but at a slower pace. The guy who's doing my car has been swamped with work (his lot was FULL today, plus inside the shop...) but he promises it won't be too long before it'll be done.
I can't wait.
The trunk lid is almost done, although it was nice to begin with...
The lower right edge of the body line is whacked right on the crease and under both tail lights are dents from where the rear bumper was drilled into the quarters at one time in my car's past. This was all cleverly hidden with a HUGE application of Bondo....
Here's the drivers side being pulled. The entire rear valance is seperated from the quarter panel. He's not sure if it'll be easier to just graft in the areas from the quarter panel skins I brought out to him. I left before he made a decision.
Next week I'll run out there and see where we're at. Updates to follow.