any body use stuff by pypes?

I sure hope their better than they were 2 yrs. ago because I bought one of their 2-1/2" stainless kits (btw: it's cheap stainless, not polished, except the mufflers) for my 68 Cuda and it didn't fit worth a crap. The X pipe was made so narrow it wouldn't even clear the yoke on the rearend and mine has the small yoke. I realize that when the car is sitting on the ground the yoke is higher than the exhaust but I want it to not rip the exhaust off when I jack the car up so I had to take it to a shop to get the X pipe re-bent. Then we went to install the tail pipes. The left fit ok but the right hung down much farther at the rear (5-6 inches). Took it back off and re-bent it. Finally got it fitting and looking decent after 2 days work and $100 to the exhaust shop.

Check out this thread about Pypes exhaust

http://www.forabodiesonly.com/mopar/showthread.php?t=31883&highlight=pypes+exhaust