Perfect intake centerline
Thanks a lot for your comments :thumrigh:
I really talked about the ICL and not the lobe centerline angle.
I am concerned with the perfekt timing of a cam.
Here the components of my engine.
Intake
Edelbrock Performer 318/360 small port
Heads
318 heads from 1970. I checked the cc.
To get the right CR of 9.5:1 to 10:1 I have to mill the heads about 0.06".
Porting
1.78" intake valve
1.6" ekhaust valve
Camshaft
Isky E-4
Valve Lift 0.425 / 0.425
.050 Duration 216 / 216
LC 108
The engine is for my 65 Valiant. I will drive the car with a 904 and for the first time with a 7 1/4 rear end (2.76).
But I will change the rear end to a 8 3/4 (3.55).
I will build a hot street car. A time on the strip of ~14.5 to 14 sec. would be perfekt.
http://www.forabodiesonly.com/mopar/showthread.php?t=132159
Regards Martin