oil leak from eddy intake
Intake was brand new out of the box and I did install it and didn't use rtv on the side gaskets I left the metal gaskets dry so which gaskets would work and should I also get a valley pan gasket
Fel-pro 1213 manifold gasket.
Comes with heat cross over block off,and Printoseal around the ports.
These are $20.00 at Summit. Seem to work very well.
I like to Edelbrock GaskaSinch (sp?) the gasket to the heads,and let dry.
Put RTV around the water jackets and a healthy amount on each end. Let the RTV set-up for a bit.
Carefully place intake manifold.
Permotex thread seal any bolts that need to be sealed and cinch them down.
Let RTV set-up a bit again before torquing.
Slowly torque to manufacturer's specs.
Let dry overnight.
Should be good to go.
Re-torque after you run it,and engine is cool.