Best and easiest to install headers

FWIW, I am using Hedman headers on the 360 in my 68 Barracuda. I installed them with the engine so it was quite straight forward but just had the drivers side out last weekend to change the steering box from a manual to power unit. There was a fair amount of items that I need to remove but all in all the drivers side header comes out and went in with a minimum of hassles.

Here is what I did;

1. put car up on jack stands about 2' in the air.
2. Disconnected the center link from the drivers side tie rod and pitman arm.
3. removed the started and z-bar for the clutch.
4. removed the steering column.
5. unbolted the header from the head and the collector from the exhaust pipe.
6. pulled the header out. With these items out of the way and a manul box the header came right out with no issues.
7. pulled the steering box.

At this point I started the installation of the power steering box and reassembly;

8. Place the power box in place but do not bolt it in.
9. un-bolt the drivers side motor mount and raise the engine as much as possible for a little more working room.
10. Place the header back into place but do not bolt it to the head. Hold it over as much as possible with a bungy cord.
11. Bolt the power steering box back into place.
12. Bolt the header to the head.

From this point on it was just a reversal of what I had removed. I started this a 9:00am on a Saturday broke for lunch at 12:00pm and was finished by 2:30pm. All in all not a bad job.