tti headers

Read the directions, Read thd directions, Read the directions! After you read them read them again! lol

1. Get the car up as high has you can. I had my car on 6 ton jack stands on top of 8 inch block of wood.

2. Torsion bar is probably coming out. On my small block the torsion bar goes through the DS torsion bar. Measure the adjuster before removing.

3. Center link needs to removed from idler arm and pitman arm.

4. I did not have a z-bar in my car when I installed. Probably need to remove as you will have to buy the one from TTI or customize yours.

5. Exhaust will need to be customized to fit the tti headers. I have the tti exhaust and it required cutting to install into my Duster.

6. Good luck and have a buddy help you pull the headers from the top.

7. Wrap the tubes in bubble wrap so they don't scratch during the installation.

8. Starter may need to come out. Mine was not in prior to installation.

9. Read the directions! and search FABO as there are a ton of threads on this subject!