Milodon Pick-up tube

Map63,

use the 2nd pic in my last post as a reference... (gasket/windage) The milodon pan uses the truck bolt pattern/layout.

The last bolt hole at the very rear corner of the gasket does not exist on the car gasket, the ribbing/seal on the gasket is the same in the area, so you would just have to drill a hole on both sides.

The car gasket/pan use the larger (structural) holes just to the outside of the missing one to secure the back corners of the pan, (compare your gasket with the PIC, and it will have extra tabs/holes there).

The one you have can be used, just drill the holes and cut off the tabs, I just decided to switch to the truck gasket because I thought there might be other differences in the gasket ribbing/seal around those rear holes.

Hope that helps,

JOE