Car is in color!!!!!!!!!!!!!

Thanks for the comments guys. I used Nason 2k clear and mid-temp activator. The temps here was 65-70 while applying the clear. Air was set at 45psi at the gun. What do you recommend for presser?
Yes Mike its the wrong color. when I first sprayed it I thought it was just the lighting. But this morning I pulled some tape off the door and there was big difference between them. I sprayed 3 coats on the first time to buff it out if needed.
For the re-paint, I will make the trip get paint from the far shop, their paint guy is a lady thats been doing it for years. Nobody else mixes their paint. Then sounds like I need to DA then wet-block sand the car with 600 to 800 grit to get the shine off. And use gray scotch bright where needed. Do I need to sand down to the paint or just the clear? Then apply 3 coats of clear. Not thought of adding hardner to the clear. But I guess it would not hurt. Anyother thoughts to this?
I used a HVLP gun for the paint and clear. SO I assume that I should not use HVLP on the clear? I do have another gravity fed gun that is not HVLP. Do I spray the clear on light or heavy?

Again thanks ofr all the help FABO.