brass jet stuck in carb, a small success story

I bought a 4brl carb and intake from fellow members for an upgrade I've been planning. When I took the carb apart the brass jet's notch for the screwdriver broke and the jet got stuck. DusterDude72 gave me good advice on how to remove this thing but I have not had access to the tools necessary until recently. the pics show that jet port with the old jet finally gone and another jet screwed in, along with the remains of the old jet.

So heres how this was done per DD72's advice
I stuck it on a drill press and drilled progressively bigger holes in the brass jet, doing so until basically only the threads of the jet remained. DD72 advised to at this point take a screwdriver just smaller then the thread diameter and hammer it down into the remainder of the jet and it should fall apart. Well this didnt work so i just retapped it and got most the brass threads out. Then I stuck a small screw driver in there and forced the remaining piece out. saved my $50 investment :icescrea: and defeated that evil jet :evil2: