Anyone make any Sebring seat brackets...

I just started this swap in my 68 charger. I was under the impression that 96-98 cars were the only ones with the seperate SCTM. be careful and check before you buy. I was lucky enough to buy mine from a guy whose girlfriend blew the motor in her 98 so I got the seats/wiring, clips, plugs and SCTM. We started this the other night and got most of the passenger seat done. I don't think that A and B body floorpans are that different. Not saying the finished product would interchange, but I think the basic strategy to make them is the same. We straight cut the bottom of the sebring brackets and but welded .120 wall steel to it, cut it front to back at the correct angle, then welded a piece at 90 degrees to the upright part. after it's final fitted we will gusset it and paint.