post badest stock stroke small blocks

Well I'm not the baddest but it does okay and there's more stock in it than just the stroke lol.

367c.i. Stock crank and rods all balanced very well
10:1 SRP forged pistons
Very mild port job on x heads with 5/16" stem 2.02/1.60 SS valves with 5 angle VJ
Comp cams XS282S= .520/.540 and 244/252 dur at .050
Crane 1.5 roller rockers
Holley strip dominator with Proform 750DP carb

trans was a 727 with 3500 stall and nothing else fancy
with a 4.56 gear in my 74 duster at around 3150lbs it went 12.24 @112mph with awful 1.80 60' time. There's a lot more in it, trans just blew up and then mangled the driveshaft and broke bad enough to kick the pass. side ear off the block and shatter the 727 case to pieces. Gona do a new trans and put these guts into a new block and finally get some good numbers. BTW this was a budget build that IMO had good bang for the buck.