Funky Rack and Pinion installation

I Just acquired a 67 Barracuda 340S. Unfortunately the guy I got it from didn’t know anything about it, as he took it in trade for some land in the desert. It has a built 340 with nitrous and an automatic trans. Runs really strong but steers funky. Upon further investigation I found that someone has butchered in a rack and pinion system and the geometry is all messed up. I took it to an alignment shop, and they aligned it the best they could, but it still is not right. It will track straight now, but it binds up and wanders all over the road and the tires scrub badly when turning, especially when backing up.

I am at a loss and really want to drive this wonderful Mopar. Does anyone know of a rack and pinion setup that I can install to replace this unknown rack? I have seen the aftermarket k member setups, but I don’t have that kind of money right now.

Anyone in the Riverside / San Bernardino areas of So Cal that might be knowledgeable in this area?

Any advice will be greatly appreciated.

Thanks

Harry

PS…. I’m trying to figure out how to post pics