Well it's been about 3 weeks since my last progress pics, haven't really done a lot of work found about 25 more holes in the engine compartment to fill in, that part is finally ready for some filler. Starting my 3rd week at my new base and decided to get busy learning the Flow Jet machine. My first project was a sturdy trunk divider panel, since I removed the angled supports the factory came with, I see a couple guys going this route but I wanted to do something diffrent and that could serve a potentially usefull purpose, I added a 12"x24" bolt in access door in case the trunk mechanism would ever fail, it is made out of .090 4130 and the reinforcement ring is .1875 to hopefully reduce any flex and give it some rigidity. I also am trying to patiently wait for my wheels to arrive so I can start on the rear axle and suspension, I went a 17"x11" Billet Specialties wheel with 4.5" BS.. Hope you enjoy the pics..
